Publicidad
Idiomas disponibles
Idiomas disponibles
Before You Call for Service
If the appliance appears to be malfunctioning, read through
this manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
Problem
Appliance not cold enough
(See "Set temperature" on page 10)
Appliance too cold
(See "Set temperature" on page 10)
No interior light.
Light will not go out when door is
closed
Noise or Vibration
Appliance will not run.
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Possible Cause
•
Control set too warm
•
Content temperature not stabi-
lized.
•
Excessive usage or prolonged
door openings.
•
Airflow to front grille blocked.
•
Door gasket not sealing properly.
•
Control set too cold
•
Door gasket not sealing properly.
•
Light bulb is burned out
•
Display light is turned on. (Glass
door models only.
•
Door not activating light switch.
•
Failed light switch
•
Appliance not level
•
Fan hitting tube obstruction.
•
Appliance turned off
•
Power cord not plugged in.
•
No power at outlet.
14
WARNING
!
Electrocution Hazard
• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the unit's wiring.
• Replace all parts and panels before operating.
•
Adjust temperature colder. Al-
low 24 hours for temperature to
stabilize.
•
Allow temperature to stabilize for
at least 24 hours.
•
Airflow must not be obstructed to
front grille. See "clearances" on
page 4.
•
Check door alignment and/or
replace door gasket.
•
Adjust temperature warmer.
Allow 24 hours for temperature to
stabilize.
•
Check door alignment and/or
replace door gasket.
•
Replace light bulb, see page 12.
•
Turn off display light, shut door.
•
Appliance not level, level appli-
ance, (See page 4, "leveling legs")
•
Verify the door is aligned properly,
refer to page 13 for instructions.
•
Contact a qualified service techni-
cian.
•
Level appliance, see "Leveling
Legs" on page 4.
•
Contact a qualified service techni-
cian.
•
Turn appliance on. See "Starting
your beverage center" on page 10.
•
Plug in power cord.
•
Check house circuit.
Remedy
Publicidad
