Publicidad
Idiomas disponibles
Idiomas disponibles
Analysis of common problems
Abnormal phenomenon
The working indicator
light is not on and there
is no fog
Indicator light on, no fog,
no wind
It has been turned on, no
fog and no wind
There is no reaction when
pressing the fog amount
key
The amount of fog is
small
Note: after the analysis of the above phenomena, the fault cannot be removed.
Please contact our company After sales customer service or dealer contact.
All manuals and user guides at all-guides.com
Cause analysis
Is the power plug plug-
ged in properly
Only display temperature
and humidity, not on
The red indicator light is
on and there is not enou-
gh water in the tank
Is constant humidity
mode on
Fog volume cannot be
adjusted in constant hu-
midity mode
The atomizer has scale,
dirty water or long stora-
ge time
Terms of settlement
Plug in the power plug
again
Press the on key to start
the machine
The amount of water
should not be too small,
and then add water to
the water tank. Check
whether the float at the
bottom of the water tank
can move normally; re-
move the sealing ring
and spring on the water
tank cover and re install it
(take down the filter ele-
ment with filter element)
In the constant humidity
mode, when the humidi-
ty is enough, it will stop
working automatically.
Need to continue to fog,
press the constant hu-
midity key to turn off the
constant humidity fun-
ction)
Press the constant hu-
midity key to turn off the
constant humidity mode,
and then press the fog
amount key to adjust
Clean the atomizer and
replace the clean water
ENG
11
Publicidad
