Descargar Imprimir esta página

Roadstar TK-100P Manual De Instrucciones página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
not use the kettle and return it to your dealer.
After the kettle has switched off automatically, there may be a short delay before it can be
re-boiled - this is usually no more than 20 seconds.
The safety cutout will operate if you accidentally switch your kettle on when it is empty.
Wait 15 minutes for the cutout to reset before refilling with cold water.
Never immerse the kettle or base in water (or any other liquid) and do not allow water to
penetrate its electrical parts to prevent electrical hazards.
Ensure that the kettle and its mains cable are kept out of the reach of children and pets.
Close supervision is necessary when this appliance is used near children.
The outside surface will get very hot during use. Always take care when handling your
Always ensure that the kettle is switched off before removing from the base unit.
Beware of steam being emitted from the spout or lid, especially during refilling.
This kettle is intended for normal household use only.
This kettle is intended for boiling water only, nothing else.
It must not be used for anything other than its intended purpose.
Do not use this appliance outside.
Do not insert any objects into holes or slots in this appliance.
This appliance must not be placed on or near any objects that heat up (such as a gas
or electric hob).
Do not allow the mains lead to hang over the edge of the work surface, touch sources
of heat or become knotted.
Do not operate this appliance if the mains lead or plug are damaged, or if the appliance
malfunctions or is damaged in any way. Check the mains lead regularly for signs of
damage.
No user-serviceable parts inside - refer to qualified service personnel.
Make sure that the mains power cable is not placed where it can be inadvertently pulled or pinched.
USING THE KETTLE
NOTE:
Before first use, fill with water to the maximum mark, bring to the boil and discard - this
will ensure that your kettle is perfectly clean.
Filling
WARNINGS!
Do not overfill as boiling water may be ejected from the spout.
English
3
kettle.
English
4
Lift the lid. Fill to the desired level between the MIN (0.25 liter) and MAX (0,5 liter) marks on the
water gauge.
Close the lid by pressing firmly until you hear a click.
Switching On
To switch the kettle on, push the On/Off switch (D) up. The Power Indicator (G) will light.
Switching Off
When the water has boiled the kettle will switch off automatically. You can stop the boiling process
at any time by pressing the On/Off switch down.
WARNING!
Never open the lid if steam is coming from the spout.
CARE & MAINTENANCE
Cleaning
Disconnect from the mains supply before cleaning.
Use a damp cloth to clean the exterior of the kettle.
Never use harsh chemicals or abrasive cleaning agents as these may damage the finish of your
kettle.
Decalcification
Decalcify your kettle at least twice a year using a proprietary descaling solution (follow the
manufacturers instructions carefully).
Alternatively, half fill the kettle with water, add the juice of a lemon or some vinegar, then boil and
allow to stand for 15 minutes.

Publicidad

loading