Philips HR1869 Manual Del Usuario página 7

Never use any accessories or parts from other manufacturers or that Philips does not speciically
-
recommend. If you use such accessories or parts, your guarantee becomes invalid.
- For a stable stand of the appliance, always keep the countertop and the bottom of the appliance clean.
- Make sure all parts are correctly assembled before you switch on the appliance.
- Only use the appliance when the locking arm is in locked position.
Only lower the locking arm to unlocked position after you have switched off the appliance and
-
the ilter has stopped rotating.
- Always unplug the appliance after use.
safety feature
This juicer is itted with a safety feature which safeguards against overheating due to excessive loads.
-
In case of overheating, the juicer automatically activates the overload protection and switches itself
off. If this occurs, set the control knob to 0, unplug the appliance and allow it to cool down for 15
minutes. Remove the juice jug and detach the lid, juice collector and the integrated pulp container
and then press the overload protection button on the bottom of the motor unit (Fig. 2).
Electromagnetic ields (EMF)
This Philips appliance complies with all standards regarding electromagnetic ields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientiic evidence available today.
preparing for use
1 Make sure all detachable parts are clean (see chapter 'Cleaning') and assembled correctly.
2 Unwind the mains cord from the base of the motor unit (Fig. 3).
3 Assemble the integrated pulp container onto motor unit (Fig. 4).
4 Assemble the juice collector onto the integrated pulp container (Fig. 5).
Assemble the ilter onto the driving shaft of the motor unit. Make sure the ilter is itted
5
securely onto the driving shaft (Fig. 6).
6 Assemble the lid onto the juicer (Fig. 7).
7 Lift the locking arm to locked position (Fig. 8).
Place the lid on the juice jug to avoid spattering (Fig. 9).
8
Note: The integrated foam separator ensures clear juice as an end result.
9 Place the juice jug under the spout (Fig. 10).
Note: If you want to extract juice straight into a glass, use the spout accessory (Fig. 11).
using the appliance
The appliance only functions if all parts are assembled correctly and the locking arm is in locked
position.
Wash the fruit and/or vegetables and cut them, if necessary, into pieces that it into the
1
feeding tube.
2 Make sure the juice jug is placed directly under the spout (Fig. 10).
3 Turn the control knob to setting 1 (low speed) or 2 (normal speed) to switch on the
appliance (Fig. 12).
All manuals and user guides at all-guidesbox.com
EnglisH
7