Before Using The Iron For The First Time; How To Use The Iron - HAEGER New Tailor 1.2 Instrucciones De Uso

English

Before using the iron for the first time

1. Remove any sticker or protective foil from the soleplate.
2. Let the iron heat up to maximum temperature and pass the iron over a piece of damp cloth for several
minutes to remove any residues from the soleplate.

How to use the iron

1. Insert the plug into a 220 – 240volt power outlet and turn the power on.
2. Turn the temperature dial to the desired setting by aligning the setting on the dial with the temperature
indicator. The thermostat light will illuminate to indicate that the iron is heating to the selected temperature.
When the thermostat light goes out the iron is at the selected temperature and is ready to iron.
NOTE: When the temperature dial is changed from a high setting to a lower temperature setting during ironing,
the thermostat light will go out immediately. This indicates that the iron is cooling to the selected temperature.
To ensure that the iron has reached the selected temperature and is not too hot, wait until the thermostat light
comes on again and then goes out before ironing.
3. Check the fabric guide label for the required ironing temperature:
4. If you do not know what kind or kinds of fabric an article is made of, determine the right ironing temperature
by ironing a part that is not visible when you wear or use the article.
a. Silk, wool and synthetic materials: iron the reverse side of the fabric to prevent shiny patches.
b. Start ironing the articles that require the lowest ironing temperature, such as those made of synthetic
fibres.
4
• Synthetic fibres
•• Silk- Wool
••• Cotton, Linen
Low temperature
Medium temperature
High temperature
Instructions for use