Publicidad
Idiomas disponibles
Idiomas disponibles
Spray job with overhead objects
3. container filled with coating material.-Tighten the screw gun.
4. power supply connecting, make sure that the voltage is consistent with the name-
plate.
5. switch on the unit. spray pattern and Amounts of material setting, Air flow and
pressure setting set
6. trigger on the spray gun.
Note:
With the unit on flows the air cap standing in air.
Adjustment of the spray gun
Setting the desired spray pattern
1) The spray pattern shape is adjusted by turning the ears of the air cap to either the
vertical, horizontal, or diagonal positions.
To adjusting spray pattern, unscrew the union nut counterclockwise to remove from
the spray gun, pull and turn the ears on air cap to the requested position.
2) Screw the union nut back to the spray gun.
3) Test each pattern and use whichever pattern is suitable for your application.
Warning:
Never during the setting of the Air cap pull the trigger
Adjustment of the rate of spread
Selection spray patterns
A = vertical flat jet
for horizontal surfaces.
B = vertical flat beam
for vertical surfaces
C = circular jet
for corners, edges and others
FIG. 4
The material volume by turning the set screw.
+ Right-turn more Rate of Spread
-Left-turn-less Rate of Spread
FIG. 5
10
Publicidad
