Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Searing Side Burner Assembly
(a)
Loosen (2) preinstalled truss head screws
from left side of Firebox (A) as shown. Do not
screw out fully; leave ¼ extended for shelf
assembly. Through side burner shelf keyholes,
hang side burner shelf (O) on two loosened
screws. See Fig.16.
(b)
Using (2) Truss head screws (AA), (2) Flat
washer (DD), attach side burner shelf (O) to
grill head from inside the firebox. Insert (2)
Truss head screws (BB), (2) Flat washer (EE)
attach the side burner shelf front panel to the
control panel, see Fig.16. Fully tighten the two
loosened screws to secure shelf to firebox.
6.
Searing Side Burner Valve Assembly
(a)
Remove the 2 screws that are pre-attached to
the valve. Insert the side burner valve into the
side burner control panel and bezel. Then align
the valve through the side burner panel
opening, making sure the orifice end is aligned
in the burner opening. See Fig.17.
(b)
Loosen the "C" bracket on the burner tube
located on the underside of the side shelf bowl
by removing the screw holding it in place. Turn
the "C" bracket so the opening of the side
burner tube is exposed.
(c)
From the front of the side burner control panel,
put the two valve screws through the knob
bezel and secure to valve. See Fig. 18.
(d)
Return to the underside of the side burner and
turn the "C" bracket to close the gap in the front
opening of the side burner tube. Tighten screw
to secure. See Fig.19.
Fig.19
Fig.16
O
Fig.17
Fig.18
O
15
A
Publicidad
