AMURA CASTOR 16A3D Manual De Instrucciones página 42

English
Do not use any accessory on this machine outside of
those recommended by Garland since its use could
result in serious injury to the user, machine, and the
people, animals and things close to the machine.
6.4.2. STARTING THE ENGINE
Start the engine carefully, in accordance with the
instructions, and feet away from the milling cutters.
6.4.2.1. STARTING THE MACHINE
Place the machine on a flat and stable surface to start
it.
1. Machine ignition key (17) in "ON".
2. Put the start/stop lever (3) in start position "I".
3. Put the fuel cock (12) in the open position.
4. Put the decompression lever in the open position
.
5. Place the accelerator lever in the maximum
position. .
6. Start the machine with the ignition key or pull the
rope (21) in case of manual start.
7. Set the throttle lever to the proper rpm.
8. Let the engine warm up for a few minutes before
starting to use the machine.
6.4.2.3. ENGINE STOP
1. Place the throttle lever in the lowest rpm position
and allow the engine to idle for a few seconds.
2. Put the machine ignition key (17) in the "0" (stop)
position.
3. Set the start/stop lever (3) to start position "0".
4. Close the fuel cock (12).
6.4.3. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully. In case of
any malfunction or problem take the machine to a
service technician to be repaired. In any case continue
to use the machine if the operation does not seem
appropriate.
Do not use the machine if it is damaged or
improperly adjusted.
7. MACHINE USAGE
Use this machine only for the designated
purposes. Using this machine for any other use is
42/144
Turtle = Minimum
Hare = Maximum