DINUY RE PLA LE2 Instrucciones De Uso página 2

EN
INSTRUCTIONS MANUAL
Ref. RE PLA LE2
DIMMER FOR 12 - 48VDC SINGLE-COLOR LED
STRIPS
TECHNICAL FEATURESS
Supply voltage
Power consumption
Suitable type of lamps
Maximum load
Minimum brightness
level
Dimming speed
Control
Dimensions
Weight
Permitted ambient
temperature
Storage temperature
Type of protection
According to the
Standard
*NOTE: The power supply associated with this dimmer must comply
with the Low Voltage Directive 2014/35/EU and EMC Directive
2014/30/EU.
DESCRIPTION
● Dimmer switch for 12-48VDC LED Strips up to 8A, with Pulse Width
Modulation technology (PWM), specially designed for single-color
LED strips.
● Small size dimmer, only 19mm thickness, for mounting into junction
box.
● Resettable protection against overload and short-circuits.
● Heating protection, not resettable from 125ºC on.
● Pushbutton control, with or without memory.
● Can be used a pushbutton referred to Groung (P1) or a pushbutton
referred to 230V~ (P2) or both.
● With two function rotary switches:
· "min": minimum brightness level (1% "+" ~ 60% "-").
· "dim speed": dimming speed between 3sec "-" & 10sec "+" (from
0% to 100%).
INSTALLATION
1 - Switch the power supply off.
2 - Install the dimmer according to one of the two wiring diagrams:
(P1) Pushbutton referred to Ground (e.g.: new installation).
LED Strip
(P2) Pulsador aislado referido a 230V (por ejemplo: reforma).
LED Strip
3 - Make sure the load is connected and supply the dimmer.
4 - Switch the LED strips on with a brief press. Then do a sustained
press until reaching the minimum light level. If the minimum light
level is correct and there is no flickering leave unchanged.
Otherwise, turn the "min" rotary switch until reaching a stable
value.
OPERATION
● Press briefly the pushbutton to switch the LED strips on at its
maximum level (NO MEM) or at the dimming level before switching
them off the last time (MEM)
● With a sustained press the LED strips will be dimmed. In order to
change the dimming direction release the pushbutton and press it
again
● To switch the LED strips off, press briefly the pushbutton.
DINUY, S.A. Auzolan, 2, 20303, IRUN, SPAIN
One-colour 12-48VDC LED Strips
From 0% to 100%: 3sec ~ 10sec
Pushbutton referred to Ground or
Pushbutton isolated referred to 230V~
IP20 according to DIN EN 60529
+
-
Power supply
L
230V~
N
+
-
Power supply
L
230V~
N
www.dinuy.com
12 - 48Vcc*
12mA
8A
1% ~ 60%
46 x 46 x 19mm
23g
0ºC ~ +40ºC
-30ºC ~ +70ºC
EN 60669-2-1
Mem
+
12-48VDC
No Mem
Mem
V- V+/LED+ LED-
+
12-48VDC
-
No Mem
dim
speed
RE PLA LE2
12 - 48Vcc
8A Máx.
V- V+/LED+ LED- PUL P2
P1
P1
dim
speed
RE PLA LE2
12 - 48Vcc
8A Máx.
PUL P2 P1
P2