Publicidad
Idiomas disponibles
Idiomas disponibles
UA protection and bulb explosion
Do not view the beam directly. Do not use the equipment without the lens. The lens and the light head
covers should be timely replaced if appears any sign of damage or rupture. The device should be used
with the protection screen together.
Prevention of electric shock
The electrical connection must only be carried out by qualified personal. Before installing, be sure to
connect it to an electrical network that works under the same parameters.
The device must be properly grounded, installed in accordance with the relevant standards. Turn off
the power when stalling or replacing the lamp and the fuse. Don't use the device during a lightning
storm or wet environment.
To prevent burning of fire
1. Never install the device directly on the surface of ordinary combustible material.
2. Do not short-circuit the temperature protection switch or fuse and use the specified type of fuse in
case of replacement.
3. The equipment must be installed away from inflammable and explosive materials.
4. The equipment must have about 3 meters around free space.
5. Fans or ventilation must not be covered.
6. Do not place any object on the lens.
7. Allow the device to cool 20 minutes before storing.
8. Do not replace with non-original spare parts. Contact your MARK dealer.
Transport protect lock
In order to protect the equipment, the device has a vertical lock to avoid unwanted movements.
During the transport, the lock must remain closed.
About packing
1. Before storing the device, make sure the power is off and wait for at least 20 minutes to cool it down.
2. Before cleaning the lens, make sure X, Y axis are locked.
3. After packing it in its plastic bag, carry and move it using the two handles besides the product and
put the product into the flightcase.
4
Publicidad
