Publicidad
Idiomas disponibles
Idiomas disponibles
TERMOENCOLADO SALKI
MALFUNCTIONS AND PROBLEM SOLVING
The glue stick
does not slide
The glue stick protrudes
from the gun
Prolonged or continuous
dripping after pressing
the trigger.
Melted glue comes out
of the back and blocks
the stick
The glue does not
come out uniformly
Improper bonding
The bond comes undone
when it cools
Glued tiles come off
The soles of shoes
come off
Strings of glue appear
when removing the gun
from the glued surface
The material of the part
being glued melts
Burns on fingers
MODELS AND RECOMMENDATIONS
25W DETAIL
40W ESSENTIAL
For detailed
Easy crafts on
work.
cardboard, plastic,
cork, lightweight
wood, string.
1. The glue stick has been used up or is too short. Insert a new glue stick.
2. Check that the glue stick has the correct diameter.
1. Check that the glue stick has the correct diameter.
1. Check the type of glue used and make sure that the melting temperature is
appropriate.
1. Check the diameter and type of glue stick used (the melting temperature may
be too low).
1. Check the type of glue stick and follow the recommended pre-heating
procedure. Press the trigger slowly and steadily.
1. The glue has completely or partially cooled. Pre-heat the already glued
surface with a hair dryer or a paint stripper to separate the parts. It is
recommended to work faster and apply the glue in dots or strings.
1. There may be grease or dirt on the surfaces being glued or the materials
may be incompatible. Remember to clean the surfaces beforehand and
use the appropriate/special glue according to the use/manufacturer's
recommendation.
1. Moisture filtration or the use of an inappropriate glue. Consider the use of
specific non-hot-melt glues for construction.
1. The material being glued has moisture or an inappropriate glue is used.
Check the type of glue used.
1. Release the trigger and finish applying the glue from the nozzle by pressing
it against the surface or part being glued.
1. You are working on a heat-sensitive material with an inappropriate gun/
glue. Check the gun + glue combination. If the material is heat sensitive, it is
recommended to do a test before the final work.
1. Check that the glue does not filter through the paper, cloth, cardboard, etc.
If necessary, place the parts being glued on a resistant base.
2. If necessary, use a clamp to hold the parts being glued.
40W LOW TEMP
For use with
heat-sensitive
materials:
styrofoam, EVA
rubber, cloth, etc.
60W ADVANCE 80W INTENSIVE
Decoration and
DIY tricks or
DIY Special for
applications for
upholstery.
advanced users.
18
80W CORDLESS
DIY tricks or
applications
for advanced users for
work at heights,
outdoors and inside
vehicles.
Publicidad
