Chauvet Professional REM 3IP Guía De Referencia Rápida página 3

AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Power Linking
It is possible to power link REM 3IP and REM 3IPSQ products. See the table below for the current draw at each voltage
and frequency:
REM3IP
Current Draw
REM3IPSQ
Current Draw
Never exceed 12 A on a single circuit. Power-linking cables can be purchased separately.
Mounting
Before mounting this product, read the
or the M10 threaded mounting holes on the product. Make sure the mounting devices are capable of supporting the
weight of the product. For our Chauvet line of mounting clamps, go to http://trusst.com/productcategory/truss-clamps.
Mounting Diagram
Alignment conical (x2)
M10 threaded mounting hole
M10 threaded mounting hole
• Warning! The magnetic attachments are not load-bearing, and are intended for alignment
assistance only. Do not release panel until the hanging hardware has been fully secured.
• The M10 mounting points are not intended for hanging or suspending from a truss or other overhead structure.
REM 3IP and REM 3IPSQ QRG Rev. 2
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
100 V, 60 Hz 120 V, 60 Hz
3.0 A
100 V, 60 Hz 120 V, 60 Hz
1.5 A 1.25 A
Safety Notes. Use rig bars (REM-RB50CMIP or REM-RB100CMIP) from Chauvet,
Latch
Latch
Latch
Latch
Wire (Europe)
Green/Yellow
208 V, 60 Hz
2.5 A 1.44 A
208 V, 60 Hz
0.72 A
Alignment bolts (x4)
Brown
Blue
230 V, 50 Hz
1.3 A
230 V, 50 Hz
0.65 A
Curve receiver
Receiver
M10 threaded mounting hole
Curve receiver
Curve receiver
Latch
M10 threaded mounting hole
Corner protector
EN
Screw Color
Yellow/Brass
Silver
Green
240 V, 50 Hz
1.25 A
240 V, 50 Hz
0.63 A
2