Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Please remember the "Z" and "Y" are reversed. To configure, use the other
letter than the one desired to get the right result.
5.2.2 DPI
In the DPI settings, you have the option of configuring 6 individual DPI levels for
each profile.
5.2.3 LED
The logo light indicates which profile is currently active. The following are the
default colours of the pRESTORE DPI levels:
• Red: DPI level 1
• Blue DPI level 2
• Blue: DPI level 3
• Violet: DPI level 4
• Yellow: DPI level 5
• Turquoise: DPI level 6
You can adjust the LED lighting of the logo separately for each DPI level. You can
select the colour, brightness and breathing-speed (pulsing) as desired to custom-
ise the appearance. The respective DPI colours can be adjusted under "Lightning".
5.3 Creating macros
Macros are recordings of specific key sequences, which can be run by pressing a
single mouse button depending on the configuration. This can, for example, be key-
strokes or mouse commands. To define a macro, please click on the desired key as
described in section 5.2.1. and then select the corresponding macro from the list.
To start recording a new macro, open the "Macro Editor" and click on "NEW MA-
CRO" first and then specify a name. Afterwards, the recording can be started by
clicking on "START RECORD" and finished with "STOP". Additional recording op-
tions are available for recording the steps :
1) "Cycle until the key released" - Repeats the macro as often as the key is held
down.
2) Cycle until any key pressed - Repeats the macro until you press the key again.
16
English
Publicidad
