Publicidad
INSTALLATION
- Install the monitor away from sources of light and heat.
- Fig. 1 - Fix the monitor mounting plate to the wall with a distance of about
1.4 m between the bottom edge and the ground (Fig. 5).
- Make the connections on the monitor terminal block.
- Fit the monitor following the direction of arrows 1 and 2 (Fig. 6).
1,40
The plate can be mounted using a 3-module flush-mounted back box (ho-
rizontal or vertical) or with pressure plugs.
Mounting points
Fig. 7
EN
Fig. 5
Fig. 6
1
1
1
1
VIDEO SIGNAL STABILISATOR
On the monitor intercommunication card there is
a connector (A-B-C) and a jumper for the video
signal balance (Fig. 9). This jumper must be
used on the installations where there are more
appliances (interphones or monitors) connected
in series (Fig. 8).
Displace the jumper into "B" (Termination 100
Ohm) only on the last set and keep the jumpers
on the other appliances in the initial position "A"
(No termination).
For other connection configurations see the:
TERMINATION TABLE FOR THE TWO WIRE
ELVOX INSTALLATIONS" shown in the wiring
diagram section.
2
2
Fig. 9
Fig. 8
C
B
A
B
A
A
A
7
Publicidad
