General Safety Instructions; Special Safety Instructions For This Device - Clatronic IC 2800 Instrucciones De Servicio

5....-05-IC 2800
GB
• Read the operating instructions carefully before putting the appliance into ope-
ration and keep the instructions including the warranty, the receipt and, if possi-
ble, the box with the internal packing.
• The appliance is designed exclusively for private use and for the envisaged pur-
pose. This appliance is not fit for commercial use. Do not use it outdoors (except
if it is designed to be used outdoors). Keep it away from sources of heat, direct
sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the
appliance with wet hands. If the appliance is humid or wet, unplug it immediate-
ly. Do not put it in water.
• When cleaning or putting it away, switch off the appliance and always pull out
the plug from the socket (pull on the plug, not the cable) if the appliance is not
being used and remove the attached accessories.
• Do not operate the machine without supervision. If you should leave the work-
place, always switch the machine off or remove the plug from the socket (pull
the plug itself, not the lead).
• To protect children from the dangers posed by electrical appliances, make sure
that the cable is hanging low and that children do not have access to the appli-
ance.
• Check the appliance and the cable for damage on a regular basis. Do not use
the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always contact an authorized
technician. To avoid the exposure to danger, always have a faulty cable be
replaced only by the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

Special Safety Instructions for this Device

• Do not operate the machine when it is left unattended.
• Do not insert your fingers into the crushing mechanism!
Overview of the Operational Controls
1 Collection vessel
1. Take the device and the accessories out of the box. Remove any packaging
materials that may be present. Then clean the accessories as described in the
"Cleaning" section.
2. Attach the accessories as shown in the diagram.
3. Please ensure that the switch (3) is set to "0".
4. Connect the machine to a correctly installed 230V, 50 Hz power socket.
22
09.04.2003 13:34 Uhr

General Safety Instructions

2 Bowl
Operation
Seite 22
3 Switch