Publicidad
Idiomas disponibles
Idiomas disponibles
English
WARNING: Do not attempt to disassemble the unit or make repairs to the equipment. Send the equipment back
to the manufacturer, or persons or entities authorized in writing by the manufacturer to make repairs to the
equipment.
WARNING: NEVER use bleach or bleach solutions
WARNING: Do not force dry with heat,
always dry the lanyard by hanging to air dry.
WARNING: Training must be conducted without exposing the trainee to a fall hazard. Training should be
repeated on a periodic basis.
LANYARD KEEPER
When not in use, unused lanyard legs still attached
to a full body harness D-ring, should not be attached
to a work positioning element or any other structural
element on the full body harness unless deemed
D
WALT
acceptable by the Competent person.
harnesses
E
come with lanyard keepers located at the sternal
area(Fig.A), specially meant for parking the unused leg
of the lanyard (Fig.B). These also reduce tripping and
entanglement hazards of the lanyard.
LANYARD KEEPER
Fig A
Fig B
ADDITIONAL INFORMATION FOR
INTERNAL ENERGY ABSORBER
LANYARDS
Training: It is essential that the users of this type of
equipment receive proper training and instructions,
including detailed procedures for the safe use of such
equipment in their work application. ANSI Z359.2.2017,
minimum requirements for a comprehensive managed
fall protection program, establishes guidelines and
requirements for an employer's managed fall protection
program. These include policies, duties and training, fall
protection procedures, eliminating and controlling fall
hazards, rescue procedures, incident investigations, and
evaluating program effectiveness
D
WALT
Internal energy absorbing lanyards meet ANSI
E
Z359.13 -2013 and are intended to be used with other
components of a PFAS and limit maximum arrest forces
to 900 lbs. (4 kN) or less.
MAINTENANCE, SERVICE AND STORAGE
D
WALT
Internal energy absorbing lanyards can be
E
cleaned with water and a mild soap solution. However,
if a lanyard is excessively dirty, or there is a build-up
of material like paint, etc., then this may hamper the
lanyard from functioning properly. In severe cases, the
12
to clean the lanyard as this may damage the webbing.
webbing may be degraded to a point where it weakens.
In such a case, remove the lanyard from service. The
hardware should be wiped off with a clean dry cloth.
D
WALT
Contact
with any questions.
E
Additional maintenance and servicing procedures must
be completed by an authorized service center.
Store the
absorbing lanyards in a cool
Internal energy
dry clean environment, away from direct sunlight. Avoid
areas where they may be in the presence of chemical
vapors, heat, excessive moisture, oil or other degrading
elements. It is extremely important to thoroughly
inspect the lanyards after extended storage.
Equipment in need of or scheduled for maintenance,
must be tagged as "unsuitable" and removed from
service.
TRAINING:
•
It is the responsibility of the user to assure
they are familiar with these instructions, and
are trained in the correct care and use of this
equipment. User must also be aware of the
operating characteristics, application limits,
and the consequences of improper use of this
equipment.
LIFESPAN:
•
The lifespan of any component of a personal fall
arrest system (PFAS) is dependent upon its level
of use, the environment in which it is used and
how it is maintained. Any part of the PFAS that
passes daily inspection by an Authorized person
or periodic (annual or semiannual) inspection
by a Competent person, can stay in use. Once it
fails visual inspection it must be removed from
service.
DISCLAIMER:
•
Prior to use, the end user, must read and
understand the manufacturer's instructions
supplied with this product at the time of
shipment and seek training from their
employer's trained personnel on the proper
usage of the product. Manufacturer is not liable
or responsible for any loss, damage or injury
caused or incurred by any person on grounds of
improper usage or installation of this product.
TWO-YEAR WARRANTY – FALL PROTECTION PRODUCTS:
THE FOLLOWING IS MADE IN LIEU OF ALL WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, INCLUDING THE
IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
THIS WARRANTY IS EXPRESSLY LIMITED TO ORIGINAL RETAIL BUYERS OF DFP SAFETY CORPORATION FALL PROTECTION
PRODUCTS OR PARTS. THIS WARRANTY IS NOT ASSIGNABLE OR TRANSFERABLE. DFP SAFETY CORPORATION MAKES
NO WARRANTY TO ANYONE ELSE, INCLUDING OTHER PURCHASERS AND/OR USERS, AND NONE SHALL BE IMPLIED.
Except as otherwise provided in this warranty, DFP Safety Corporation Fall Protection Products are warranted against
defects in materials and workmanship for two years from the date of purchase.
LIMITED REMEDY: The sole and exclusive remedy for any DFP Safety Corporation product found to be defective in
materials and workmanship is repair or replacement, at the sole option of DFP Safety Corporation, or its authorized
warranty service providers. If this exclusive remedy is deemed to have failed of its essential purpose, DFP Safety
Corporation's liability shall not exceed the purchase price of the DFP Safety Corporation product.
LIMITATION OF LIABILITY: In no event will DFP Safety Corporation be liable for any direct, indirect, special, incidental,
punitive or consequential damages (including lost profit) whether based on warranty, contract, tort, or any other legal
theory.
This warranty does not cover any DFP Safety Corporation product that has been abused, altered, worn out,
contaminated, rusted, excessively heated, ground, damaged due to improper loading, used for a purpose other than
that for which it was intended, or used in a manner inconsistent with DFP Safety Corporation's instructions regarding
use.
The existence of a defect in materials or workmanship shall be determined by DFP Safety Corporation in
accordance with procedures established by DFP Safety Corporation. No one is authorized to make any statement or
representation altering the terms of this warranty.
ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE ARE DISCLAIMED. THERE ARE NO WARRANTIES THAT EXTEND BEYOND THE FACE OF THIS
DOCUMENT.
This writing supersedes all prior oral or written agreements or representations and excludes all warranties not set
forth herein.
English
13
Publicidad
