Technical Specifications - Velleman DVM13MFC2 Manual Del Usuario

Example 2: Measuring a 30 MHz intercom emission frequency
Set the FUNCTION to the 2-step position and select the gate time (adjust manually from 100 ms to 10 s).
The LED display reads:
Example 3: Measuring a self-oscillating frequency (e.g. from a telephone, intercom etc.)
Set the FUNCTION key to the 2-step position. Connect one end of a test cable with 5 pF capacitance to
the red clamp; use the other end to measure the frequency by touching the contact point.
6. Warnings

When measuring a high-voltage or strong RF signal, make sure that the cables are in series and have
a large capacitance to avoid damage.

Press the RESET button once to reset the device or turn off the device in case the device is not
working appropriately.

When there is no input signal, the display may not necessarily read "0". This is absolutely normal and
does not affect the measurements or the accuracy.

Do not expose the device to extreme temperatures, humidity, dirt, dust, etc. Do not open the device
to avoid lethal electroshocks.

A strong interference will reduce the sensitivity when measuring.
7.

Technical Specifications

channel A (0.01 Hz to 50 MHz):
frequency range
sensitivity
impedance
attenuator
max. input voltage
channel B (50 MHz to 2.4 GHz):
frequency range
sensitivity
coupling
impedance
max. input voltage
Resolution (depends on the gate time setting)
Step Coupling
1 AC
1 AC
2 AC
3 AC
3 DC
V. 03 – 05/12/2017
DVM13MFC2
DC couple 0.01 Hz to 100 Hz
AC couple 100 Hz to 50 MHz
80 mVrms
1 MΩ
x1, x20
30 V (DC/AC peak)
from 50 MHz to 2.4 GHz
50 mVrms
AC only
50 Ω
3 V
Frequency range
1 GHz – 2.4 GHz
50 MHz – 1 GHz
(not including 1 GHz)
2 MHz – 50 MHz
100 Hz – 2 MHz
0.01 Hz – 100 Hz
(not including 100 Hz)
2-step
30 MHz
Gate time min.
1 kHz
1 kHz
1 kHz
10 kHz
4
Resolution
Gate time max.
100 Hz
10 Hz
10 Hz
0.1 Hz
0.001 Hz
©Velleman nv