brennenstuhl Power Jet-Light ELP 436 Manual Del Usuario página 8

060810 Jet Light ELP 336_436:060810 Arbeitsleuchte ELP 336_ELP 436
Power Jet-Light ELP 336 / ELP 436
Operation
Setting up the lamp
Place the lamp on a dry and even surface. Only use the lamp with the handle opened.
The lamp can be switched on and off via the switch which is located on the backside
(ELP 336 only).
Mounting the lamp on a tripod
The lamp can be mounted onto a suitable tripod through the holes on the bracket
(fixings not included!). Ensure that the tripod is sufficiently stable.
Replacing the illuminant
• Warning! Always disconnect the power plug from the mains outlet prior to performing
any kind of work on the lamp. Disregard can pose the risk of accident and / or injury!
• Warning! Let the lamp cool down completely. Disregard can pose the risk of injury.
• Use a clean, lint-free cloth to change the illuminant.
• Only use illuminants according to the specifications mentioned in the section
»Technical Data«.
• Place the work lamp with the backside facing downward.
• Remove the rubber lip by pressing it downward.
• Use a Phillips screwdriver to remove the 6 safety screws from the housing (ELP 336 only).
• Remove the lamp cover.
• Remove the illuminant's retaining clip and pull the illuminant upwards.
• Gently push the new illuminant downward into the lamp socket. Fix the illuminant by
engaging the retaining clip.
• Reattach the lamp cover to the housing.
• Fasten the lamp cover with the 6 safety screws (ELP 336 only).
• Slide the rubber lip back over the lamp cover. Ensure that the rubber lip locks the lamp
cover and housing properly.
Your lamp is ready for operation.
Maintenance and care
Important! The work lamp contains no parts that have to be serviced by the user.
Warning! Always disconnect the power plug from the mains prior to performing any kind
of work on the lamp.
Disregard can pose the risk of accident and / or injury.
Caution! For safety reasons the lamp must not be cleaned with water or other liquids,
and never be immersed into water.
Use only a clean, lint-free cloth to clean the lamp.
Do not use solvents, gasoline, etc., as this will damage the lamp.
8
25.11.10
Operating Instructions
8:43 Uhr Seite