Speedlink PECOS 420W ATX Manual De Instrucciones página 17

4-pin peripheral device connector
Pin
1
2
3
4
4-pin floppy connector
Pin
1
2
3
4
TROUBLESHOOTING
If the computer doesn't boot correctly please take the following steps:
• Make sure the power switch is set to 'I'.
• Check to see if the power cord has been correctly plugged into the power supply unit and the
mains socket.
• Check to see if all components are correctly connected to the power supply unit.
• Switch the power supply unit off, wait a few seconds, and then switch it back on again.
• If the computer still won't boot despite taking these steps, please refer to a specialist. You
should neither attempt to open the power supply unit nor modify the device!
Function
+12V
COM
COM
+5V
Function
+12V
COM
COM
+5V
Colour
Yellow/Yellow
Black/Black
Black/Black
Red/Red
Colour
Yellow
Black
Black
Red
En
17