Pur Line HYDRO 14 Manual De Instrucciones página 9

Remove the water tank.
Turn the tank upside down and open the lid.
Fill with clean cold water (max. 40ºC).
Close the water tank cap.
Install the water tank in the humidifier body.
AROMATHERAPY FUNCTION: Add a few drops of essential oil to the aromatherapy tray on the back of the
appliance.
CONTROL PANEL
TIMER button: press to set the operation time of the humidifier, from 1 to 12 hours (1 h. each press). The time
indicator is on. When the screen shows 12 hours, press the button again to turn off the time setting.
HYGROSTAT button: press to start the automatic humidification and set a desired humidity level from 45% to
90% RH. Each press set the humidity from low to high, and then close the humidity setting. The corresponding
indicator is on. Five seconds after finish the humidity setting the LCD screen display the current indoor
humidity. When the indoor humidity is higher than the setting humidity, the device stops automatically. When
the water level in the tank is too low, the device beeps and turns off automatically.
ANION button: press to start the ionization function. The corresponding indicator is on. Press again to turn the
function off.
WARM button: press to start the arm mist function. The corresponding indicator is on. After 10 minutes the cold
mist would turn warm gradually. Press again to turn the function off, the mist will turn cold soon.
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
"white powder" problem and give heavy scum on the surface of water basin, transducer and inner surface of
the water tank. Scum on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
• Use filtered water or distilled water.
• Clean the transducer, water tank and basin unit every week.
• Change the water in water tank more often to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use.
HOW TO CLEAN THE TRANSDUCER:
for 2-5 minutes. 2. Brush out the scum on the surface. 3. Rinse the transducer with clean water.
HOW TO CLEAN THE BASIN UNIT:
scum in it. 2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with
the brush. 3. Rinse the water basin with clean water.
CLEAN THE TANK FILTER:
Shake about 10 times and rinse with water. 4. Leave to dry.
EN
1. Put 5-10 drops of vinegar on the surface of the transducer, wait
1. Clean the water basin with soft cloth and the vinegar if there is
1. Remove the filter from the tank. Clean with a little vinegar and clean water. 3.
ON/OFF: press to turn on the device, the LCD
screen display the environment humidity and
temperature.
When the water level in the tank is too low, the
indicator "Lack" flashes, the device beeps and
turns off automatically.
When there are water in the water tank, press
the power button, the device starts to work with
high level of humidification. Press again to turn
off.
HUMIDIFY button: press to adjust the mist
quantity: low, medium, high and power off. The
corresponding indicator is on.
7