Makita HM1317CB Manual De Instrucciones página 5

Indicator lamp
► 1. Power-ON indicator lamp (green) 2. Service
indicator lamp (red)
The green power-ON indicator lamp lights up when the
tool is plugged. If the indicator lamp does not light up,
the mains cord or the controller may be malfunction.
The indicator lamp is lit but the tool does not start even
if the tool is switched on, the carbon brushes may be
worn out, or the controller, the motor or the ON/OFF
switch may be malfunction.
The red service indicator lamp flickers up when the
carbon brushes are nearly worn out to indicate that the
tool needs servicing. After approx. 8 hours of use, the
motor will automatically be shut off.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Side handle (auxiliary handle)
1
2
► 1. Set bolt 2. Nut 3. Side handle
The side handle can be swung 360° on the vertical and
secured at any desired position. Just loosen the clamp
nut to swing the side handle to a desired position. Then
tighten the clamp nut securely.
Installing or removing the bit
For Model HM1307C,HM1317C only
1
1
2
2
► 1. Bit 2. Tool retainer 3. Tool holder
With the notched portion on the shank of the bit facing
toward the tool retainer, insert the bit into the tool holder
as far as it will go. Then pull out and turn the tool retainer
180° to secure the bit. After installing, always make sure
that the bit is securely held in place by trying to pull it out.
For Model HM1307CB,HM1317CB only
► 1. Bit with collar 2. Bit without collar
This tool accepts bits either with or without a collar on
its shank.
(1) For bits with a collar
1
2
3
3
► 1. Bit 2. Tool retainer 3. Tool holder 4. When the bit
is inserted 5. When the bit is retained
5 ENGLISH
3
1
2
4
5