Livoo AR320 Manual De Instrucciones página 9

Press the RADIO/SLEEP button twice to enter the sleep mode. The display will show "SLEEP" and the time
remaining before entering standby.
Press the RADIO/SLEEP button again to set the time until the radio goes to sleep or to cancel the sleep
mode.
When the clock is displayed again, press the RADIO/SLEEP button twice to display the remaining time.
When the sleep time setting is complete, the radio will automatically turn off when the set time has
elapsed.
When the sleep function is activated and the clock is displayed, you can press the Snooze button briefly
to cancel the sleep function.
Power of the display
You can adjust the power or switch off the display by briefly pressing the "DIMMER" button. There are 3
display powers available.
Projection function
When the radio is switched off, press the PRO button briefly to start the light projection function. Press the
button again to increase the brightness and press again to stop the projection function. The projection is
adjustable from 0 to 180 degrees.
Note: When the light projection is on, you can turn on the radio.
You can adjust the sharpness of the projection by using the knob directly on the projector. You can
project from 12cm to about 3 meters.
Note: You can insert a battery CR2032 (not supplied) into your device to save your settings in case of
power failure (Figure 2).
The USB port on your alarm clock allows you to charge your phone etc (Figure 2).
Cleaning and maintenance
Use a dry cloth to clean this product.
When not in use, make sure the unit is properly turned off and stored in a cool, dry place.
DECLARATION OF CONFORMITY
We, DELTA BP61071, 67452 Mundolsheim - France, declare under our own responsibility that the radio equipment :
Radio alarm clock with time projection - reference AR320 to which this declaration applies, is in conformity with the
applicable EU harmonization legislation:
DIRECTIVES
(RED) 2014/53/EU (EMC)
2014/30/EU
ROHS 2011/65/EU
Mundolsheim, 25/10/2022
David Bousquet, CEO
Signature:
Battery Advice and recycling
STANDARDS or Requirements
ETSI EN 301 489-1 V2.2.3 (2019-11) ; ETSI EN 301 489-3 V2.1.2 (2021-03)
ETSI EN 303 345-1 V1.1.1 (2019-06) ; ETSI EN 303 345-3 V1.1.0(2019-11)
EN IEC 62368-1 2020+A1 2020 ; EN 50663: 2017
EN IEC 61000-6-3 2021 ; EN IEC 61000-6-1 2019
The object of the declaration described above is in conformity
with Directive 2011/65/EU of the European Parliament and of the
Council of 8 June 2011 on the restriction of the use of certain
hazardous substances in electrical and electronic equipment.
7