Stiebel Eltron Ultronic-1 Plus Funcionamiento E Instalación página 9

OPERATION
Troubleshooting
Wipe the appliance casing regularly with a soft, damp cloth.
Clean the air intake area on the underside of the appliance
regularly with a brush.
7. Troubleshooting
Problem Cause
The appliance does There is no power.
not start.
Covering the IR sensor
can impair the function of
the appliance. When used
without interruption, the ap-
pliance stops automatically
after approx. 50 seconds to
avoid constant operation.
The LED on the At least 60,000 applications
front of the appli- with the built-in HEPA filter
ance flashes red. have been reached. The
filter must be replaced.
The appliance can still
be operated without the
filter function. After ap-
prox. 75,000 applications,
the appliance can no longer
be operated until the filter is
replaced.
www.stiebel-eltron-usa.com
Problem
The blue LED on
the underside
of the appliance
flashes.
If you cannot solve the problem, contact your qualified contractor.
Solution
To facilitate and speed up your inquiry, please provide the serial
Check whether a circuit
number from the type plate (000000-0000-000000).
breaker has tripped in the
main breaker panel.
Check that the appliance is
installed correctly on the
wall mounting bracket.
Check whether any objects
etc. are interfering with the
IR sensor detection range.
After removing the interfer-
ence factors, the appliance
operates normally.
Ask a qualified contractor to
replace the HEPA filter.
Cause
The PCB or fan motor is
faulty.
™
Ultronic Plus & Premium Hand Dryers |
Solution
Contact a qualified con-
tractor.
9