Samsung WA45T3400AP/A4 Manual Del Usuario página 27

Idiomas disponibles

STEP 6 Running a test cycle

Run a test cycle as follows to check if your washer is properly installed.

1. Load about 6 pounds of laundry into the tub.

2. Press POWER to turn on your washer.

3. Select Rinse+Spin by turning the Cycle Selector.

4. Press START/PAUSE to start the test cycle.

5. The washer should not rock or vibrate excessively when water is supplied or when

washing or spinning, and should drain well during the spin cycle.

NOTE

If water leaks while water is being supplied or drained, check the water connections. Refer to

the "STEP 2 Connecting the water supply hose" section on page 20 for instructions.

NOTE

If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP

4 Leveling your washer" section on page 25 for instructions.

STEP 7 Run calibration (recommended)

Calibration ensures accurate weight detection by the washer. Make sure the tub is empty

before running calibration.

1. Press POWER to turn on the washer.

2. Press and hold Temp. and Delay End simultaneously for 3 seconds.

3. Press START/PAUSE to start calibration.

4. The tub rotates clockwise for approximately 2 minutes.

5. When complete, "0" appears on the display, and the washer turns off automatically.

NOTE

Run Calibration Mode periodically for more accurate weight detection.

WA3400T_DC68-03850E-04_EN.indd 27

English 27

2021-01-29

12:42:33