Publicidad
Idiomas disponibles
Idiomas disponibles
To assure maximum performance of the device, please note the following
recommendations:
1. For best result, do not locate the device in an area with a high rate of air
fi ltration and movements as the warm air will be exhausted
2. Try placing the device near a warmer inside wall and direct the output
toward a cooler outside wall. The cooler outside wall will tend to draw the
generated heat toward itself, which will allow for more effi cient heating.
3. Placing the device next to a cold air return will draw the heat away from
area to be climate. Try closing or covering the cold air return. This will
allow for more effi cient heating.
4. To ensure maximum effi ciency, a 40% (minimum) relative humidity
should be maintained in the heated environment.
5. When the device is placed in an isolated area (basement, recreation
area...) the delivery registers and air return grills of the existing system
should be closed in that area if possible.
6. In rooms with large areas of bare concrete, try placing the device a few
feet above the fl oor. Make sure the device is secure and won´t fall. This
will allow for more effi cient heating since concrete acts as a heat sink
and will tend to draw the heat in its direction.
7. Try setting your central heating system to a lower temperature and
placing the device in the area you spend most of your time. Now set the
device to your control level.
8. When heating larger areas, place the device in a central location, if a
ceiling fan is nearby, try using it at the same time to help distribute the
heat evenly.
9. If used in an extremely dirty or dusty area, the fi lter must be cleaned
more frequently as it can clog and cause the heater to stop working.
RECOMMENDATIONS
16
Publicidad
