1. Unpackage device. Put the unit on fl at surface. Please, keep the
package for off -season storage and any transportation needs.
2. Put your unit on the table or a fl at surface.
3. Plug the power cord directly into an unused grounded 220-volt 10amp
or higher circuit receptable.
4. After plug into power, unit will go into Standby mode, Power indicator
will turn on and WIFI indicator will be blink, you could choose to connect
it to WIFI or not, please see WIFI function part for more information.
5. Press the Power button to turn on the unit then all indicators will turn on
except the Swing indicator, it will turn on after you set the swing angles.
6. Under working condition, you could change diff erent mode (Ventilation-
Low Heating- High Heating) by press the Mode button, the indicator
will show on accordingly. You could press the Fan speed button to set
diff erent fan speed levels under diff erent modes as bellow:
•
Fan speed level under Ventilation Mode. Level 1 to 10
•
Fan speed level under Low heating Mode. Level 4 to 10
•
Fan speed level under High Heating Mode. Level 6 to 10
7. Press Light Button on both control panel and remote control to turn on
the Reading Lamp, it has two diff erent luminance, you could change
it by press the Light button either under Standby condition or Working
condition.
8. Press the Swing button to choose the swing angles, you could set 60,
90, 180 degrees or turn it off , the indicator will turn on accordingly after
you set the angles.
9. Unit has Memory function to memorize the settings before you turn off
the unit except the Light setting, you will need to set it again after you
turn on the unit.
10. The unit will continue to work for around 25 seconds after you turn off
the unit when it is working under Heating Mode to cool the unit.
11. Unit has Tip-over switch to make sure the safety, if the unit is tilted over
45 degrees over 3 seconds, then unit will turn off automatically, after you
make it upright over 3 seconds then you could turn on the unit again.
20