Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - Powerworks P24LM32 Manual Del Operario

3. Move the axle into one of the three positions. Make
sure that the two sides of the axle are in the same
height.
4. Make sure that the four wheels are assembled in the
same cutting height and scroll smoothly and
unclogged.
3.5

INSTALL THE BATTERY PACK

Figure 5
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
NOTE
The engine starts only when you put in the safety key.
3.6

REMOVE THE BATTERY PACK

Figure 5
1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

WARNING
Wear eye protection during operation.
4.1

START THE MACHINE

Figure 6.
1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the switch box
handle in the direction of the handle bar.
4. Release the start button to start the machine.
English
4.2

STOP THE MACHINE

Figure 6.
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the safety key and battery pack after
you complete the work.
4.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it
from the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
4.4

OPERATE ON SLOPES

Do not mow on the slopes with decline more than 15°.
If you are not comfortable, do not mow on a slope.
Please keep a low self-propelled speed when you
mow on a slope.
• Do not go up and down on a slope when you mow
across the face of the slope. Be careful when you
change the direction on a slope.
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
4.5

OPERATION TIPS

• Do not try to override the operation of the start
button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
5
WARNING
WARNING
WARNING
WARNING
EN