Sears Kenmore 116.22085 Manual Del Propietário página 11

Electrical Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed to
prevent motor failure and/or
electrical shock.
Check motor safety filter occasionally
and clean when dirty,
1. Unplug cord
from wall out-
let and remove
bag°
2. Pull out
safety filter as
shown.
3. Wash filter in warm soapy water, rinse,
then dry_ Do not clean in dishwasher or
install while damp,
4. Snap filter
back into canis-
ter.
5. Insert bag.
This vacuum has a thermal protector which automatically trips to protect the vacuum from
overheating. The thermal protector turns the motor off automatically to allow the motor to cool
in order to prevent possible damage to the vacuum.
To reset: Turn off and unplug the vacuum from the outlet to allow the vacuum to cool, Check
for and remove any clogs. Also check and replace any clogged filters, Wait
approximately 50 minutes and plug the vacuum in and turn back on to see if the thermal
protector has reset, In some cases, the unit may suddenly restart. DO NOT leave
unattended,
1, Unplug cord from wall outlet. Do not drip
water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning.
3. To reduce static electricity and dust build-
up, wipe outer surface of cleaner and
attachments.
DO NOT USE ATTACHMENTS IF THEY
ARE WET.
!
• CAUTION ........................
Attachments used in dirty areas,
such as under a refrigerator, should
not be used on other surfaces until
they are washed.They could leave
marks.
11