Publicidad
Idiomas disponibles
Idiomas disponibles
Loosen and remove the nuts, gaskets, and the skid shoe from the bolts (Fig.15A).
1.
2.
Replace the skid shoe with a new one, if necessary. (PN: GMA-SS)
3.
The height of the skid shoes can be adjusted according to the actual snow
conditions without removing the nuts. Just loosen the nuts, adjust the skid-shoe
position up or down, and then retighten (Fig.15B).
4.
Ensure the shoes are adjusted to the same height on both sides.
Gasket
Bolt
Skid shoe
Nut
Fig.15A
7.5 REPLACE THE SHEAR PIN
Auger is sharp. Always wear gloves when performing any maintenance on the auger.
Do not at any time make any adjustments to the machine without first removing the
battery packs.
NOTE: The shear pins are located in the auger shaft. They aid in absorbing the instant stall
torque when the auger strikes obstacles during working and protect the gearbox and motor
from damage.
1.
Remove the locking pin from the shear pin on each side and then pull out the
broken shear pin. (Fig.16)
Carefully align the auger to the auger shaft and insert the new shear pin (GMA-SP)
2.
into the slot, then insert the locking pin to secure the auger. (Fig.16)
Shear pin
2
1
Page 24-English
Fig.15B
Fig.16
GREEN MACHINE 62V CORDLESS SNOW BLOWER
7.6 REPLACE THE AUGER
Auger is sharp. Always wear gloves when performing any maintenance on the auger.
Do not at any time make any adjustments to the machine without first removing the
battery packs.
NOTE: The auger will become worn during operation, change the auger every 50hrs of
working time.
1.
Remove the three screws on both left and right of the auger housing (Fig.17A).
Remove the auger, together with the gearbox as a whole set from the housing.
2.
Then remove the flange, bushing, and gasket from the auger shaft (Fig.17A).
3.
Remove the left and right shear pins and separate the augers from the auger shaft
(Fig.17B).
Replace the worn auger (GMA-24A) and reassemble them in reverse order.
4.
Screw
Bushing
Flange
Gaskete
Auger
Fig.17A
7.7 TRANSPORT AND STORE THE SNOW BLOWER
Do not store or transport the snow blower while it is running. Always remove the battery
packs before storing or transporting them.
■
Lift the front of the machine while transporting and crossing gravel or road surfaces.
■
Always exercise caution to avoid the sharp auger, even when your machine is turned off.
■
Before storage, wipe any moisture, dirt, or debris from the battery area.
■
Wipe the snow blower with a clean dry cloth.
■
Check all nuts, bolts, knobs, screws, etc., for tightness.
■
Inspect moving parts for damage, breakage, and wear. Have repairs made on any
damaged or missing parts.
■
Fold the side rails to the storage position.
■
When not in use store the machine and battery in a dry, well-ventilated area, out of the
reach of children.
■
Do not store near corrosive materials such as fertilizer or rock salt.
GREEN MACHINE 62V CORDLESS SNOW BLOWER
Auger
Auger Shaft
Shear Pin
Fig.17B
Page 25-English
Publicidad
