Maintenance And Inspection - EGAmaster 56494 Manual De Instrucciones

1. The application for interchangeable heads is the same as for the sockets. It can only be used in
the specified torque range. Any incorrect operation will damage the interchangeable heads and
the wrench.
2. To ensure proper operation, use our heads only with our wrenches and vice versa.
APPLICATION:
Put the interchangeable head into the torque wrench according to the marked direction,
making sure that the pin is fixed correctly and the wrench is ready for use.
- Set the torque to the lowest setting following use to relieve stress on the compressive spring.
- Only clean the unit using dry materials – do not dip it in petrol or solvent.
- Do not disassemble the wrench for any reason.
- With the exception of the ratchet mechanism, do not lubricate the wrench.
The wrench should be re-calibrated periodically. The calibration of the wrench should be
checked at least once a year, after any abnormal use or overloading, or after 5.000 cycles.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the Testing Pump
being incorrectly used or, applied for a purpose for which it was not intended.
The maker guarantees to the machine owner garantie ilimitee against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
INSTRUCTIONS FOR INTERCHANGEABLE HEADS

MAINTENANCE AND INSPECTION

CALIBRATION
NOTES
GUARANTEE
13