Makita 2107F Manual De Instrucciones página 5

Lighting up the lamps
► 1. Lamp switch
CAUTION:
• Do not apply impact to the light, which may
cause damage or shorted service time to it.
To turn on the lamp, press the "I"(ON) side of the lamp
switch. Press the "O"(OFF) side to turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
• Do not use thinner or gasoline to clean the lamp.
Such solvents may damage it.
• After operation, always turn off the light by
pressing the "O (OFF)" side.
Hook (Optional accessory)
► 1. Hook
The tool may be hung using the hook. Hang tool on a
pipe vice or other suitable, stable structure.
ASSEMBLY
•
1
Installing or removing the blade
•
•
Turn the blade tightening lever clockwise until it hits
against the protrusion on the frame.
► 1. Tighten 2. Loosen 3. Protrusion 4. Lever
Match the direction of the arrow on the blade to that of
the arrow on the wheels.
1
► 1. Blade 2. Bearing 3. Upper holder 4. Lower holder
5 ENGLISH
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
CAUTION:
Oil on the blade can cause the blade to slip or
come off unexpectedly. Wipe off all excess oil
with a cloth before installing the blade.
Use caution when handling the blade so that
you are not cut by the sharp edge of the blade
teeth.
4
1
3
1
3
2
4
2