Start-Up - Luxia POLY 1000 Manual De Uso Y Mantenimiento

To start the dishwasher:
1) Open the loading water tap and activate the
switch at the mains.
2) Insert the overflow pipe (1) into the proper
hole, making sure that the rotor (in models
with a square basket) can rotate freely.
3) Press the starting switch (2) to load the water
into the tank and heat it up.
4) Pour in the appropriate amount of detergent
(non-foaming type) unless a detergent pump has
been installed; apply the dose recommended by
the detergent manufacturer.
5) Wait for the water to heat (this depends on the
temperature of the mains water).
6) Load the basket, place it in the wash position
and close the covers using the handle (3).
7) Press the timer pushbutton (4).
8) Wait for the wash cycle to end and execute a
hot rinse.
9) Open the door, wait a few seconds and take
out the basket with the clean dishes.
NOTE: Acting on the manual selection pushbutton (5) allows you to select automatic
mode.
In this case it is no longer necessary to press the timer pushbutton at the start of
every cycle; closing the machine covers will automatically start the cycle.
pag. 42 di 132

21 - START-UP

POLY 1000/1500/2000
ModelsPOLY1000 and POLY1500:
1
2
Model POLY2000:
1
2
Operating and service manual
English
3
4
3
4
5