ETA Systems 350VA Manual Del Usuario página 13

ETA SYSTEMS - UNINTERRUPTIBLE POWER MANAGER
If Communications Manager software is installed on the host PC, Configuration Manager can use it to adjust
both Low Voltage Transfer Point and High Voltage Transfer Point. The following table provides the
allowable set points for adjusting transfer voltage (key in all three numbers shown).
Low Voltage Transfer Points (key in all three numbers)
Model
North American
International
High Voltage Transfer Points (key in all three numbers)
Model
North American
International
Low Battery Warning Time: Low battery warning time can be configured for either two or five minutes
before UPM shutdown depending on the requirements of the application. It should be noted that these times
are at full load with a healthy battery. Partial loads and/or aged batteries will affect the accuracy of this timer
setting.
Receptacle On/Off Control: Set the turn-off times of the receptacle groups and individual receptacles on
the rear panel.
Start Manager
When AC power is not available, such as in a new installation where wiring may be incomplete, you can still
start the UPM to test its operation and the operation of your system using Start Manager. With the UPM off,
follow these simple steps:
1. Disconnect the input AC power cable from the rear panel of the UPM.
2. Set the rear panel Start Manager switch to "Enable".
3. Press and hold the On/Off switch on the front panel until the UPM beeps.
Set Pt. Set Pt. Set Pt. Set Pt.
1 2 3
089 091 093
176 181 186
Set Pt. Set Pt. Set Pt. Set Pt.
1 2 3
141 145 148
282 290 296
11
4
096
192
4
151
302