Publicidad
Idiomas disponibles
Idiomas disponibles
Quick guide
Pour cold water into the bath so that it reaches the liquid level sensor but does not go
over the maximum fill line.
Add the required dose of detergent (see page 24).
Switch on the machine via the switch at the rear of the unit, just above the electrical
mains lead.
Press the " " key to accept the programmed cleaning cycle settings and start the
cleaning cycle.
At the end of the cleaning cycle, remove the basket from the bath and rinse the cleaned
items under clean running water. The lid can be inverted and the basket placed on top
to catch excess liquid as the items dry.
REMEMBER
-
Always keep the bath full of liquid when in operation
-
Do not put hot water above 50°C into the bath
-
Always use the basket
-
Never expose hands, fingers or other body parts to cleaning solutions
-
Never use toxic, flammable, acidic, caustic or corrosive solutions
-
Never breathe the fumes from strong solutions
-
Rinse the items in clean water once the cycle is complete
Subjecting the bath to improper treatment or misuse will invalidate the warranty.
xub Series
Operating Manual
5
Maximum
Fill Line
EN
29666 V5
Publicidad
