Quick Start - Ecler nuo 4.0 Manual De Instrucciones

4. QUICK START

Install and connect the NUO4.0 as described in the INSTALLATION paragraph nº1.
We will describe a "Quick Start" procedure using the LINE input of
channel 1 and headphone monitoring output only.
1. Set the controllers to their initial position
Set the rotating controllers GAIN, HI, MID and LOW from channel 1 (3, 4,
5, 6) to their central position. Set the channel's fader (11) to its lower end
and assign the A/OFF/B switch (10) to position A (the channel is now
assigned to the crossfader's A side).
2. Connect the headphones
Connect them to the headphones output (30). Set the headphones
LEVEL controller (29) to minimum level and move the SELECT (28)
controller into PFL position.
3. Connect a CD player
Connect a CD player to LINE input on channel 1 (36), insert a CD and
play the CD.
4. Connect the mixer's power cable
Connect the power cable to the mixer's power supply input (43) and turn it
on using the MAINS INPUT switch (45). Both elements are located on the
mixer's backside.
5. Select the input source
Make sure that channel 1's input switch (1) is in LINE position and that
the channel's VU-meter (2) glows up. If this doesn't happen, verify that
the CD player is correctly connected and that there is an audio track
being played back.
6. Adjust the input level
Move the GAIN (3) control until the VU-meter shows 0dB.
7. Send the signal to the main output
Move the fader from channel 1 (11) all the way up and set the crossfader
(12) to side A.
8