Samsung SND-7080 Manual Del Usuario página 4

Inside
Item
Monitor Out
a
Reset Button
b
SD Memory Card
c
Compartment
Wiring Cover
d
Lock Release
e
 _ English
Using the test monitor cable, you can connect to a mobile display for camera
test.
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Compartment for the SD memory card.
If you drill a hole in the wiring cover for wiring,
remove the cover and attach the provided dustproof
plate to it, and arrange the cables through the plate.
The dust-proof plate is to prevent outside dust from
inflow to the wiring compartment.
To separate the bracket from the main unit for the installation or to separate
the camera from an installed camera, push this release and turn the main
unit in the marked direction of <UNLOCK>.
Description