Dyna-Glo EG10000DH Instrucciones De Instalación Y Mantenimiento página 12

1. Before cleaning, make sure the power has been turned off at the circuit breaker
panel and that the heating element of the heater is cool.
2. To maintain the external appearance of the heater, the unit occasionally needs to
be wiped with a dry duster. During the summer months, or at other times when
the appliance is not in use and is completely cold, it should be the wiped over
with a damp cloth.
3. Do not use abrasive clearing powders or furniture polish. Do not use chemical or
abrasive products, metallic scourers and so on, which may deteriorate the sur-
face, to clean the appliance.
4. During the summer months, or at other times when the appliance is not in use,
disconnect the power supply. Keep the appliance in a dry and cool place.
5. All other servicing should be performed by qualified service personnel. Do not try
to repair the heater yourself.
NOTE: The motor is permanently lubricated, and no further lubrication is needed.
Part Description
1 Back mesh
2 Hanging plate
3 Fan Blade
4 Air guide plate
5 Large handle seat
6 Small handle seat
7 Spring
8 Motor
MAINTENANCE
REPLACEMENT PARTS
Part#
EG10000DH001AC
EG10000DH002AC
EG10000DH003AC
EG10000DH004AC
EG5000005AC
EG5000006AC
EG5000007AC
EG10000DH005AC
Part Description
9 Heater
10 Selection Switch
11 Main Board
12 Terminal block
13 Temperature CUT-OFF
14 Control Panel Circuit Board EG7500DH002AC
15 Control Panel box
16 Infrared Remote Control
12
Part#
EG10000DH006AC
EG5000011AC
EG7500DH001AC
EG5000014AC
EG5000017AC
EG7500DH003AC
EG7500DH004AC