Publicidad
Idiomas disponibles
Idiomas disponibles
Auger is designed to work in forward motion. Excessive reverse motion could cause binding. If resistance is felt while pulling
spreader backwards, stop and clear salt from auger.
ASSEMBLY INSTRUCTIONS
Approximate assembly time is 5-10 minutes
Suggested Tools:
Wrench and/or Ratchet Set
• Assemble handle to uprights with Hex bolts and nuts.
• Tighten M6 nuts completely.
• Attach bail assembly spring to gate control (Fig. A).
* Note: If spring detaches from bail assembly, simply re-attach (see Figure A).
Bolts
Handle
AUGER INSTALLATION
• Screw auger onto impeller shaft. Screw auger retaining nut into auger hole with M6 socket driver. Tighten completely with wrench to secure.
GENERAL OPERATING INSTRUCTIONS
• Be sure gate control is in the closed position (do not hold bail down when filling)
• Determine appropriate setting for material being used by reading the suggested setting on the material's bag. Be sure to read the instructions on the bag/box
of the material you're
spreading to identify accurate setting needed)
• To begin spreading, start walking (about 3 mph pace) and pull the bail system down to open gate
• To stop spreading simply let go of the bail and the gate will close
STORAGE AND MAINTENANCE
• When finished spreading empty hopper of any remaining material
• Thoroughly wash spreader and allow to dry before storing
• To fold down handle:
- Simply remove the bottom two bolts on the handle
- Loosen two M6 Hex nuts and fold down handle
- Replace two bottom bolts
- Tighten M6 Hex nuts completely
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
WARNING
M6 Hex
Nuts
Figure A
Fully Assembled
Publicidad
