Status Monitor (3-Color-Led); Fault Detection; Technical Data - BriskHeat BH-330 Operación Manual

BH-330 Inline Controller Operation Manual
4

Status monitor (3-color-LED)

After connecting to power supply, the controller starts with a self-test: white LED on for 1 sec. Self-test
successfully completed and controller starts heating: green LED on for 0.3 sec.
If a failure would be detected a default signal will show up: see section 5 Fault detection.
The heat-up phase is continuous until the set-point temperature has been reached: blue LED on/off with
a frequency of 1 Hz
Set-point temperature reached:
If the set-point is reached, the LED turns permanent green. The controller works at set-point with a
max hysteresis of +/- 3°K
Temperature monitor:
During operation the temperature is permanently under control. The LED remains green in between
the hysteresis of ±3 K at set-point temperature. Above and below this temperature range the LED
starts to blink with a frequency of 1Hz. Blue signals too low and red too high temperatures.
5

Fault detection

From start and during operation the controller is permanently checking PCB temperature, power sup-
ply and sensor break. If any failure occurs the controller stops heating (stand-by) and fast blinking
indicates the error. Only after disconnecting from power supply and reconnecting, the controller will
restart and continue operation. On initial Start-up, if there is nothing connected to the output, a Sensor
Failure will occur.
1. PCB temperature > 85°C
2. Device failure:
3. Sensor failure
®
© BriskHeat Corporation
®
. All rights reserved.
5
BH-330 Inline Controller Operation Manual
6

Technical data

Nominal Voltage 90 - 260 VAC 50/60 Hz
Nominal Output 1100 Watt
Peak Output @ 230 V (5 min) 1600 Watt
Nominal Output @ 115 V 550 Watt
Peak Output @ 115 V (5 min) 800 Watt
Rated Current max. 10 A
Thermal Protection + 85°C (Electronic Temperature, Self-Reset)
WRL330P: PT100-RTD on Potential
Sensor
WRL330K: Type-K Thermocouple on Potential
WRL330P: -25°C - 600°C
Adjustment Range
WRL330K: -200°C - 1350°C
Controller Type FAT (Fast-Adaptive-Tuning)
Ambient Temperature -20°C to +45°C
Relative Humidity 0 - 100%
Protection Standard IP67
Display 3-colored LED, signaling the operating modes
Operation Requires WRZF310N-BH01 IR Remote Control (BH-310)
Weight 0.4 Kg
Protection Class 1
Input (power): 2-pin grounded European plug, 1.5 m long
Connections (Standard)
Output (heater): 6+PE finder series 693, 0.6 m long
®
© BriskHeat Corporation
®
. All rights reserved.
6