en-US
References to illustrations
The illustrations referred to in the text
are shown on the fold-out pages at
the end of these Operating Instruc-
tions.
Handheld Turbobrush features
The handheld Turbobrush is operated
by the suction power of the vacuum
cleaner. It has a rotating roller brush
which is very effective at vacuuming up
thread, hair and fluff.
Recommended use (Fig. 01)
When using the handheld Turbo-
brush, please also observe the IM-
PORTANT SAFETY INSTRUCTIONS
in your vacuum cleaner instruction
manual.
This handheld Turbobrush is particularly
suitable for vacuuming upholstery, mat-
tresses, car seats and carpeted stairs.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
Fitting the handheld Turbo-
brush
Connect the handheld Turbobrush to
the handle or suction wand on your
vacuum cleaner depending on how
you wish to use it.
72
Using the handheld Turbo-
brush
To achieve the best effect, pass the
handheld Turbobrush slowly back-
wards and forwards over the surface
being vacuumed.
Maintenance
Always turn off the vacuum
cleaner and unplug it before cleaning
or servicing the Turbobrush.
Removing threads and hairs
(Fig. 02 - 04)
With a pair of scissors (Fig. 02)), cut
any threads or hairs that have be-
come entangled on the roller brush.
Then run the vacuum cleaner to vac-
uum up the bits.
For more tangles or blockages inside
the handheld Turbobrush, the cover can
be opened. Any large particles can then
be easily removed (Fig. 03).
Twist the connector until the release
button is located in the center of the
slot .
Then press release button and pull
the connector away from the hand-
held Turbobrush .
Open up the brush compartment as
far as you can and then remove any
stubborn soiling from the compart-
ment interior and from the roller brush
(Fig. 04).
Finally close the cover to the brush
compartment and push the connector
back into position over the release
button.