REV Ritter ESBH-10B+ Manual De Instrucciones página 10

SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
TECHNICAL DATA
• These products contain a light source of energy efficiency class E
• Illuminant: SMD LED´s
• Nominal values: 230V~; 50Hz
• Colour temperature: 6500K
• Ra/CRI: ≥ 80
• LED service life: 25000h
• Beam angle: <120°
• IP protection class: IP44
• Protection class: II (S7)
• Ambient temperature: -10°C – 35°C
• Continuous operation possible
Type
ESBH-10B / ESBH-10C
ESBH-14B / ESBH-14C
INSTALLATION
• ATTENTION!! Before installation, the power supply must be disconnected from the mains and secured against
being switched on again (S4).
• Please refer to the drawings for the installation steps.
• Use a wire cross-section of 1.5mm² for connection.
• Do not connect the lamp to a dimmer.
CLEANING
• Disconnect the product from the power supply and secure the circuit from being switched on again.
• Allow the luminaire to cool down sufficiently!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
MAINTENANCE
• Replace any damaged protective panels immediately (S8).
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
Performance Luminous flux
10 W 700 lm
14 W 1000 lm
LED LED
1
Light source not
1
interchangeable!
Luminous efficacy
70 lm/W
71 lm/W
Control gear not interchangeable
2
(ballasts, power supply units, etc.)!
GB
Dimension
LxBxH: 197 x 197 x 95mm
Ø: 197mm
2
10