Numark TTi Manual De Inicio Rápido Para El Usuario página 5

11
8
6. Power Button: Turns the unit on and off.
7. Platter: This platter must be securely fastened to the turntable prior to operation. The
Motor Drive Belt can be found on the drive ring underneath the platter. See SETUP
INSTRUCTIONS for detailed information on installing the Motor Drive Belt.
8. Start/Stop Buttons: This button starts and stops the turntable motor. If the button seems
to not be functioning, check to make sure that the Motor Drive Belt is properly installed in
the SETUP INSTRUCTIONS.
9. 1/8" Stereo Line Input: Connect Tape Players, Reel to Reel, or any other audio source
here. This signal is sent to the computer through the USB. Make sure that your phono
cartridge is installed while using this input for maximum sound quality. Also make
sure that your RCA jacks are either plugged into an input device or not in contact with
metal.
10. 33 and 45 RPM Buttons: These buttons control the RPM of the turntable platter. A red
LED indicates which RPM mode has been selected.
NOTE: If the turntable is powered down while in the 45 RPM setting, it will return to 33
RPM when it is powered up.
NOTE: You can record your 78RPM records by recording them at 33 or 45rpm, then
changing them to 78 in the Audacity software.
6
5
6
7
23
9
10
24
19
20
21
12
13
22
14
15
16
17
18