Publicidad
Idiomas disponibles
Idiomas disponibles
RePlAceMeNT PARTS
WARNING:
To reduce the risk of personal injury, disconnect battery pack from tool
and engage trigger lock-off before performing maintenance, or clearing a jammed staple.
The tool comes equiped with a spare no mar tip (13) located on the side of the staple
magazine as shown in figure 11.
1. To replace the tip, simply pull off the old tip and slide the new tip onto the contact
trip as shown in figure 12.
Use only identical replacement parts. For a parts list or to order parts, visit our
service website at www.portercable.com. You can also order parts from your nearest
PoRTeR-cABle Factory Service Center or PoRTeR-cABle Authorized Warranty
Service Center. Or, you can call our Customer Care Center at (888) 848-5175.
11
SeRvIce ANd RePAIRS
WARNING:
magazine before making any adjustments or servicing this tool.
The charger and battery pack are not serviceable.
All quality tools will eventually require servicing and/or replacement of parts. For information
about PoRTeR-cABle, its factory service centers or authorized warranty service centers,
visit our website at www.portercable.com or call our Customer Care Center at (888) 848-
5175. All repairs made by our service centers are fully guaranteed against defective
material and workmanship. We cannot guarantee repairs made or attempted by others. You
can also write to us for information at PoRTeR-cABle, 4825 Highway 45 North, Jackson,
Tennessee 38305, (888) 848-5175 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number, etc.).
This Class B digital apparatus complies with Canadian iCES-003. This device complies
with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NoTe:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This Class B
digital apparatus complies with Canadian iCES-003.
THe RBRc™ SeAl
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
Li-Ion battery (or battery pack) indicates that the costs to recycle the battery (or
battery pack) at the end of its useful life have already been paid by PoRTeR-
cABle. RBRC™ in cooperation with PoRTeR-cABle and other battery
13
To reduce the risk of serious personal injury, remove staples from
12
15
13
Publicidad
