sunjoe SWJ599E Manual Del Operador página 17

• Mount the file in the guide and then insert it in the tooth at
a constant angle from the cutting edge.
• Sharpen in a forward motion a few times and repeat this
on all the cutting edges facing the same way (right or left).
• To move the chain forward, use a screwdriver.
• Turn the bar over in the vice and repeat on all the other
cutting edges.
• Check that the depth limiter tooth does not stick out
farther than the inspection tool and file any projecting
parts with a flat file, rounding off the edges (Fig. 22).
• After sharpening, remove all traces of filing and dust
and lubricate the chain in an oil bath. Replace the chain
whenever:
– the length of the cutting edges decreases to 5 mm
or less;
– there is too much play between the links and the rivets.
Fig. 22
Cutting edge
Guide Bar Maintenance
When the guide bar shows signs of wear, turn it over on the
saw to distribute the wear for maximum bar life. Feathering or
burring of the bar rails is a normal process of bar wear. You
should smooth such faults with a file as soon as they occur.
Replace a bar with any of the following faults:
• wear inside the bar rails permitting the chain to lay over
sideways;
• bent guide bar;
• cracked or broken rails;
• spread rails.
Inspection tool
Depth
limiter
tooth
Depth limiter tooth
17
Turn the saw over, check the underside of the guide bar, and
make sure that the lubrication holes and chain groove are free
from impurities.
You can purchase replacement parts for your Sun Joe
SWJ599E electric chain saw online at sunjoe.com or, to order
by phone, contact Snow Joe
1-866-SNOWJOE (1-866-766-9563).
Chain Sprocket
Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 23).
Do not mount a new chain with a worn sprocket or vice-versa.
Fig. 23
Storage
After every work session, clean the machine thoroughly to
remove all dust and debris and slide the bar sheath over the
cutting bar. Repair or replace any faulty parts on the unit.
Store the machine in a dry, locked place out of the reach
of children.
Support
If your Sun Joe SWJ599E electric chain saw requires service
®
or maintenance, please call 1-866-SNOWJOE (1-866-766-
9563) for assistance.
Model and Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
S W J 5 9 9 E
Serial #:
®
+ Sun Joe customer service at
® ®
< 0.5 mm