i-tec U3HDMIDVIDOCK Manual De Instrucciones página 5

chipset of your notebook / tablet / PC. Other problems can be caused by outdated
firmware of the USB 3.0 port controller. Most frequently it is one of the following
manufacturers: Intel, Renesas (former NEC), Via (VLI), AS Media, Fresco Logic, Etron.
You can find the most recent drivers for the i-tec products on our website www.i-tec.cz/en
in the „Download" tab for the individual products.
INSTALLATION OF DRIVERS IN WINDOWS 7 / 8 / 8.1 / 10 (32/64 BIT VERSION)
Before the first use do not connect the docking station to the notebook / tablet / PC, until
you install the corresponding drivers for the LAN and DVI-I. The equipment drivers need
to be installed only before the first use.
Download the required software from our website www.i-tec.cz/en from the „Download"
tab for this product. Install the drivers according to the following procedure:
For the LAN and DVI-I port run the downloaded file, select the language of the installation
and follow the instructions on the screen.
Note:
In Windows 7 / 8 / 8.1 / 10 install the DVI-I port as the „Administrator". The monitor
may be flashing during the installation of the drivers – this is a standard process. After
the completion of the installation we recommend restarting the notebook / tablet / PC.
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION TO A
NOTEBOOK / TABLET / PC)
1. Turn ON the notebook / tablet / PC and connect the power adapter to the
docking station.
2. Connect the power adapter to the AC 110 V / 230 V mains.
3. Connect the USB 3.0 cable to the USB port type B on the back on all of the
docking station.
4. Connect the USB 3.0 cable to a free USB 3.0 / 2.0 port of your notebook / tablet
/ PC.
5. Subsequently, the automatic installation of the ports in the individual systems
will start.
INSTALLATION OF DRIVERS IN MAC OS X
Before the first use do not connect the docking station to the MacBook / PC, until you
install the corresponding drivers for the LAN and DVI-I port. The equipment drivers need
to be installed only before the first use.
Download the required software from our website www.i-tec.cz/en from the „Download"
tab for this product. Install the drivers according to the following procedure:
For the LAN and DVI-I port run the downloaded file. Decompress the file on the desktop
of your MacBook / PC as a virtual disc, select "Drivers" and then „DisplayLink Software
Installer". Then select the language of the installation and follow the instructions on
the screen. Enter the user password if necessary. The monitor may be flashing during
the installation of the drivers – this is a standard process. After the completion of the
installation restart the MacBook / PC.
Quick Start
| 5
ENGLISH