Sauder Shoal Creek Serie Manual Del Usuario página 9

Step 5
Lay the ENDS (A2 and B2) fl at on the fl oor exactly as shown.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the
å
ENDS (A2 and B2) until the shoulders of the SCREWS rest on
the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (M72) onto the ENDS (A2 and B2).
å
Line up the grooves in the MOLDINGS over the heads of the
SCREWS in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS, remove it and
å
slide it on again.
RIGHT END ASSEMBLY
These edges
should be even.
LEFT END ASSEMBLY
These edges
should be even.
www.sauder.com/services
M72
32S
B2
M72
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
A2
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
409714
Shoulder
32S
Shoulder
Page 9