a specialist because under these circumstances the cover have to be removed
which assures protection against microwave radiation. This applies to changing
the power cord or the lighting as well. Send the appliance in these cases to our
service centre.
34. The microwave oven is intended for defrosting, cooking and steaming of food
only.
35. Use gloves if you remove any heated food.
36. Caution! Steam will escape, when opening lids or wrapping foil.
37. This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children unless they are aged from 8 years
and above and supervised.
38. If smoke is emitted, switch off or unplug the appliance and keep the door closed
in order to stifle any flames.
1. Make sure that all the packing materials are removed from the inside of the
door.
2. WARNING!--Check the oven for any damage, such as misaligned or bent door,
damaged door seals and sealing surface, broken or loose door hinges and
latches and dents inside the cavity or on the door. If there is any damage, do not
operate the oven and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable surface to hold its weight
and the heaviest food likely to be cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated, or
near combustible materials.
5. For correct operation, the oven must have sufficient airflow. Allow minimum
20cm of free space necessary above the top surface of the oven and 5cm at
both sides. The microwave oven rear plate must be placed close to the wall. Do
not cover or block any openings on the appliance. Do not remove feet.
6. Make sure that the power supply cord is undamaged and does not run under the
oven or over any hot or sharp surface.
7. The socket must be readily accessible so that it can be easily unplugged in an
Installation Guide
5