About the dryer features.
Wrinkle Care Option
(on some models)
Use this option to minimize the wrinkles
in clothes. It provides approximately
15 minutes of no-heat tumbling after
the clothes are dry.
This option can only be used with the
COTTONS and EASY CARE cycles.
Cycle Signal Option
(on some models)
This signal will sound just before the end
of the cycle to remind you to remove the
clothes. On some models, the signal sound
level cannot be adjusted.
If you selected the WRINKLE CARE option,
the signal will sound at the end of the
drying time and will sound several times
during the WRINKLE CARE cycle. This will
remind you that it is time to remove the
clothes.
Drum Lamp
(on some models)
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and
replace with the same size bulb.
If you are using the SIGNAL knob and you
select the WRINKLE CARE option, a signal will
sound at the end of the drying time and
several times during the WRINKLE CARE
cycle. This will remind you that it is time to
remove the clothes.
If WRINKLE CARE is not on, the dryer will stop
once the timer reaches the WRINKLE CARE
mark on the cycle dial.
NOTE:
I Remove garments promptly at the
sound of the signal. Place clothes on
hangers so wrinkles won't set in.
I Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won't set in.
7