Electrical Connections - Stiebel Eltron ULTRONIC 1 S Guía De Operación E Instalación

INSTALLATION

ELECTRICAL CONNECTIONS

8. Electrical connections
1 Wiring block
Install a 1/2˝ electrical connector in the back part of 
housing in the hole located below the wiring block
(1, above).
Feed wires through connector; tighten clamp down 
on wire.
The "live" wires must be connected to the slots 
on the terminal marked N/L and L. The ground
wire must be connected to the slot on the terminal
marked with the ground symbol.
8 | ULTRONIC 1 / ULTRONIC
™
1
2 TOUCHLESS AUTOMATIC HAND DRYERS
™
Put the housing back onto the front of the unit. 
Lift upward to reengage the hooks into the 
attachment eyelets.
Press the housing down gently so it locks in place. 
2.
1.
Turn the two screws a full turn counterclockwise to 
stop.
WWW.STIEBEL-ELTRON-USA.COM
3.