Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING TO AC POWER
Before using your Bluetooth speaker, you should connect it to AC (mains) power.
1. Plug the AC/DC adaptor into the AC (mains) power socket outlet.
2. Plug the DC power cord on the AC/DC adaptor into the DC IN jack of the unit.
When the unit is not operated by the AC power or unused for long periods of the time, please remove
the power adaptor from the wall outlet and unplug from the main unit.
POWERING ON/OFF THE UNIT
1. After connecting the AC power, the STATUS indicator would light up in RED to indicator the unit is
in standby mode.
2. Press and hold the "
3. After using the unit, pressing and holding the "
mode.
NOTE:
If the unit is idle for 2 minutes after being powered on, it will be switched to standby mode automatically.
PAIRING YOUR BLUETOOTH DEVICE
ABOUT PAIRING
Pairing is the term used when two Bluetooth devices are connected wirelessly for the first time. This
allows the devices to see each other and sets up a one to one communication channel between both
devices.
To begin pairing with a Bluetooth device
1.
After powering on your unit, you can start pairing process to connect to your Bluetooth device.
2.
If it is the first time setup after purchasing, the STATUS indicator will flash RED and BLUE
alternatively to ask for pairing. BLUE / RED flashing indicates pairing attempt is in process.
" button for 2 seconds to turn on the unit.
" button for 2 seconds to switch the unit to standby
17
Publicidad
